Jawa Blaster kit Build (Enfield)

Doing this build up for a member here. I've never put one of these kits together before (seen them around though), though not a bad little kit.

I was able to get started on it today as I need this finished and out the door before May.

Overall, the clean up was easy, but there's still a lot of little things I need to do, mostly filler. Focused on removing the mold seam lines and flashing. So far the biggest pain has been cleaning up the bottom of the actual trigger.

Before I started:




After today's work





This area with the hole is solid resin...however, this should be open, so I am slowly but surely removing it



The trigger and mag section had less clean up then the rest of the pieces, though the most difficult as mentioned above, was clearing and sanding the resn which held the trigger down





Barrel required major clean up, removed the seam lines pretty well, but had some build up on the inside of it that I removed..








And everything now properly fits together! Still need to finish some sanding and do some bondo work before I can even move forward..



More to come

-TC