Thought I would have a go at making a prop replica. Since my sculpting skills are not quite as good as most people on this network, I was thinking of alternatives and thought I would try 3D printing. I have never tried anything like it befor, so here are the results of my first attempt.
I had a picture I had taken from the HP Tour as reference. The whole thing is about 14cm by 6cm and 4cm high. I guessed the dimensions by looking at other objects in the display cases from the tour.
I dont know what to do now though. I'm scared spray painting it gold might just make it look a bit nasty and ruin the effect???
I had a picture I had taken from the HP Tour as reference. The whole thing is about 14cm by 6cm and 4cm high. I guessed the dimensions by looking at other objects in the display cases from the tour.
I dont know what to do now though. I'm scared spray painting it gold might just make it look a bit nasty and ruin the effect???